Filtration Engineered for Mining Conditions
Automatic self-cleaning filters built to handle high-sediment, abrasive water across every stage of mining operations — from raw water intake to process reuse.
Water Quality Is a Production Variable
Mining operations depend on water at every stage — drilling, dust suppression, equipment cooling, mineral processing, and tailings management. The water itself is rarely clean. Raw intake from bores, dams, and surface catchments carries fine clay particles, ferrous sediment, and suspended solids that vary with season and site conditions. Downstream, process water recirculated from tailings ponds adds further contamination load. Without reliable filtration, spray nozzles block, heat exchangers foul, pump seals wear prematurely, and downtime accumulates. Filtaworx automatic filters are sized and configured to maintain continuous, clean water supply — regardless of what comes upstream.
Where Filtaworx Filters Fit in Mining Operations
Dust Suppression Systems
Spray nozzles and cannon systems demand sediment-free water to maintain coverage and prevent orifice blockage. Automatic screen filters protect spray infrastructure and reduce maintenance call-outs across haul roads and stockpiles.
Process and Wash Water
Mineral processing circuits require consistent water quality to protect pumps, cyclones, and instrumentation. Filtration ahead of process water injection reduces abrasive wear and protects expensive downstream equipment.
Cooling and Equipment Water
Compressors, hydraulic systems, and heat exchangers are sensitive to particulate fouling. Protecting cooling circuits with automatic filtration extends service intervals and prevents premature failure in continuous-operation plant environments.
Water Reuse and Tailings Return
Recovering and reusing water from tailings dewatering reduces freshwater draw and operational cost. Filtaworx filters manage the elevated TSS and fine clay loads typical of recirculated tailings water, supporting sustainable reuse programmes.
Built for Mining Realities
Engineered for Tough Water
Mining water is among the most demanding intake water Filtaworx filters encounter. High total suspended solids, fine ferrous and clay particles, intermittent turbidity spikes from rainfall events, and the occasional brackish bore source all place stress on conventional filtration equipment. Filtaworx FW Series hydraulic automatic filters and FED Series electric automatic filters are designed to manage variable water quality continuously, with self-cleaning cycles triggered by differential pressure rather than elapsed time — so the filter responds to actual conditions, not an arbitrary schedule.
Built to Operate Where You Operate
Mining sites are not controlled environments. Filtaworx filters are designed for industrial installation conditions — remote locations, variable power supply, exposed plant areas, and maintenance access that is infrequent by necessity. The FW Series operates purely on line pressure with no external power requirement, making it well suited to remote bore and dam intake points. Where power is available, the FED Series and semi-automatic suction-scan and brush filters add programmable control and monitoring capability. All units are manufactured in Australia, with local engineering support and parts availability.
Discuss Your Mining Filtration Requirements
Every mining water circuit has different inlet quality, flow demands, and operational constraints. Talk to a Filtaworx engineer about the right filtration configuration for your site — no obligation, no generic recommendations.